Toyota Tacoma manuals

Toyota Tacoma Owners Manual: USB port/AUX port

Connect an iPod, USB memory device or portable audio player to the USB port/AUX port as indicated below. Select “iPod”, “USB” or “AUX” on the “Select Audio Source” screen and the device can be operated via multimedia system.

Connecting using the USB port/AUX port

■ iPod

Open the cover and connect an iPod using an iPod cable.

Open the cover and connect an iPod using an iPod cable.

Turn on the power of the iPod if it is not turned on.

■ USB memory

Open the cover and connect the USB memory device.

Turn on the power of the USB memory device if it is not turned on.

■ Portable audio player

Open the cover and connect the portable audio player.

Turn on the power of the portable audio player if it is not turned on.

CAUTION

■While driving

Do not connect a device or operate the device controls.

Entune Audio
Operations such as listening to audio, using the hands-free phone, confirming vehicle information and changing multimedia system settings are started by using the following buttons. Multimedia sy ...

Setup menu
You can adjust the multimedia system to your desired settings. Display “Setup” screen Press the “SETUP” button to display the “Setup” screen. Select to adjust the settings for oper ...

Other materials:

Installation
INSTALLATION PROCEDURE 1. SET NO. 1 CYLINDER TO TDC/COMPRESSION 2. INSTALL CAMSHAFT TIMING GEAR BOLT NOTICE: There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque. *a Identification Ma ...

Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact. PROCEDURE 1. INSTALL BLIND SPOT MONITOR SENSOR LH (a) Install the blind spot monitor sensor LH with the 3 nuts. Torque: 9.0 N·m {92 kgf·cm, 80 in·l ...

Rear Power Outlet Socket
Components COMPONENTS ILLUSTRATION ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL POWER OUTLET SOCKET ASSEMBLY (a) Install the clamp. (b) Connect the connector. (c) Using a torx socket wrench T30, install the 4 screws and the power outlet socket assemb ...

© 2011-2018 Copyright www.ttguide.net