Toyota Tacoma (2015-2018) Service Manual: USB Device Malfunction (B1585)

Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Audio And Visual System / USB Device Malfunction (B1585)

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No.	DTC Detection Condition	Trouble Area
B1585	USB Device Malfunction Non mass-storage class or incompatible protocol USB device USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) "iPod" malfunction "iPod" with unsupported firmware Unsupported "iPod" model	USB device or "iPod" Radio and display receiver assembly

PROCEDURE

1.	REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the ignition switch off.

HINT:

When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
Refer to System Description for compatible formats and versions (See page ).

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again. ).

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USBDEVICE OR "iPod" WAS DEFECTIVE

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

Extension Module Malfunction (B1552,B158A,B15BA)

DESCRIPTION These DTCs are stored when a malfunction occurs in the stereo component tuner assembly. DTC No. DTC Detection Condition Trouble Area B ...

AV Signal Stoppage (Low Battery Voltage) (B158F)

DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily. DTC Code ...

Other materials:

Electrical Key Oscillator(for Front Floor)
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (a) Engage the clamp to install the No. 1 indoor electrical key antenna assembly. (b) Connect the connector. 2. INSTALL FRONT CONSOLE BOX (See page ) Remov ...

Meter Illumination does not Dim at Night
DESCRIPTION In this circuit, the combination meter assembly auto dimmer signals from the main body ECU using the CAN communication system (CAN V1 Bus). When the combination meter assembly an auto dimmer signal, it dims the meter illumination (warning and indicator lights). The main body ECU ( ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System) (a) Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly. 2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System) (a) T ...