Toyota Tacoma (2015-2018) Service Manual: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System)
(a) Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly.
2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System)
|
(a) Turn the ignition switch to ACC. |
|
(b) Install the ignition switch lock cylinder assembly to the upper steering column bracket assembly.
(c) Make sure that the ignition switch lock cylinder assembly is securely installed into the upper steering column bracket assembly.
3. INSTALL KEY INTER LOCK SOLENOID (for Automatic Transmission without Smart Key System)
(a) Engage the claw to install the key interlock solenoid to the upper steering column bracket assembly.
(b) Install the screw.
4. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Smart Key System)
(a) Install the ignition or starter switch assembly to the upper steering column bracket assembly with the 2 screws.
5. INSTALL TRANSPONDER KEY AMPLIFIER (w/o Smart Key System)
(a) Engage the 2 claws to install the transponder key amplifier.
6. INSPECT STEERING LOCK OPERATION (w/o Smart Key System)
(a) Check that the steering mechanism is activated when removing the key.
(b) Check that the steering mechanism is deactivated when inserting the key and turning it to ACC position.
7. INSTALL UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Smart Key System)
|
(a) Secure the steering column assembly in a vise between aluminum plates. NOTICE: Do not overtighten the vise. |
|
(b) Temporarily install the upper steering column bracket with switch assembly with a new tapered-head bolt.
(c) Tighten the tapered-head bolt until the bolt head breaks off.
8. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Smart Key System)
HINT:
- Perform the same procedure as for the upper steering column bracket with switch assembly.
- When replacing the steering lock actuator assembly, perform initialization
(See page
.gif)
).
9. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY
.png)
(a) Align the matchmarks on the steering intermediate shaft assembly and steering main shaft assembly.
(b) Install the steering intermediate shaft sub-assembly with the bolt.
Torque:
35 N·m {357 kgf·cm, 26 ft·lbf}
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING COLUMN ASSEMBLY
(a) Install the steering column assembly with the 2 nuts and bolt.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
(b) Connect each of the c ...
Other materials:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLER CONDENSER ASSEMBLY
(a) If the fins of the cooler condenser assembly are dirty, clean them with water
and dry them with compressed air.
NOTICE:
Do not damage the fins of the condenser assembly.
(b) If the fins of the cooler condenser assembly ...
All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
DESCRIPTION
The main body ECU (multiplex network body ECU) receives switch signals from the
door control switch assembly on the front passenger door and activates the door
lock motor on each door according to these signals.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USIN ...
If your vehicle has to be stopped in an emergency
Only in an emergency, such as if it becomes impossible to stop the vehicle
in the normal way, stop the vehicle using the following procedure:
Steadily step on the brake pedal
with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required ...
