Toyota Tacoma (2015-2018) Service Manual: Theft Deterrent System
- Parts Location
- Precaution
- Customize Parameters
- How To Proceed With Troubleshooting
- System Description
- System Diagram
- Diagnosis System
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Theft Deterrent System cannot be Set or Unset
- Theft Deterrent System is not Unset when Engine is Running
- Theft Deterrent System Unexpectedly Sets Itself
- Some Alarm Functions do not Operate
- While Alarm is Armed, Battery is Reconnected but Alarm does not Sound
- While Alarm is Armed, Engine Hood is opened but Alarm does not Sound
Security Horn Assembly
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT SECURITY HORN ASSEMBLY
(a) Check the operation.
(1) Apply battery voltage and check operation o ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials:
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY
(a) Compress and extend the shock absorber rod and check that there is no abnormal
resistance or unusual sound during operation.
If there is any abnormality, replace the front shock absorber with a new one.
NOTICE:
When disposin ...
Open in ABS Solenoid Relay Circuit (C146E,C146F)
DESCRIPTION
The ABS solenoid relay is built into the master cylinder solenoid.
This relay supplies power to each ABS solenoid. After the ignition switch is
turned ON, if the initial check is OK, the relay turns on.
DTC No.
DTC Detecting Conditions
Trouble Areas
...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL COMPRESSOR PICK UP SENSOR
(a) Install the compressor pick up sensor with the 3 screws.
(b) Engage the clamp.
2. INSTALL MAGNET CLUTCH ASSEMBLY
(a) Secure the cooler compressor assembly in a vise between ...
