Toyota Tacoma (2015-2018) Service Manual: Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE
|
1. |
REPLACE CD AND RECHECK |
(a) Replace the CD with a known good one and recheck.
(1) Check if the same malfunction occurs again.
OK:
Malfunction disappears.
| OK | .gif) |
END |
| NG | |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
No Sound can be Heard from Speakers
PROCEDURE
1.
CHECK AUDIO SETTINGS
(a) Display the "Sound Settings" screen.
(b) Set volume, fader and balance to the initial values and check that sound
i ...
CD cannot be Ejected
PROCEDURE
1.
CHECK OPERATION
(a) Press the disc eject switch of the navigation receiver assembly for 5 seconds
or more and check that the CD is ejected.
OK:
CD i ...
Other materials:
Cruise Control Input Processor (P160700)
DESCRIPTION
When the ECM determines that there is a malfunction, the ECM illuminates the
MIL and stores a DTC.
HINT:
When these DTCs are stored, the ECM cuts the current supplied to the throttle
motor and the throttle valve returns to the predetermined opening amount by the
return spring.
...
A-TRAC Indicator Light does not Come ON
DESCRIPTION
The A-TRAC does not operate even if the A-TRAC switch is pressed under the following
conditions:
The TRAC or VSC system is faulty.
The temperature inside the hydraulic brake booster increases and the
A-TRAC operation is suspended.
WIRING DIAGRAM
Refer to A-TRAC ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable f ...
