Toyota Tacoma (2015-2018) Service Manual: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY
(a) Engage the 2 claws to install the No. 1 stereo jack adapter assembly.
2. INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL
(See page .gif)
)
3. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
(See page )
4. INSTALL FRONT CONSOLE BOX
(See page )
5. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
(a) for Automatic Air Conditioning System (See page
)
(b) for Manual Air Conditioning System (See page
)
6. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY
(See page )
7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
(See page )
Removal
REMOVAL
PROCEDURE
1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
(See page )
2. REMOVE LOWER INSTRUMENT PANEL ASSEMBLY
(See page )
3. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
...
Other materials:
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Disconnect the C27 and C29 certification ECU (smart key ECU assembly) connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side w ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. REMOVE NO. 1 FRONT WHEEL OPENING EXTENSION PAD (w/ Front Spoiler)
2. SEPARATE FRONT FENDER LINER
(a) Remov ...
Clock
Adjusts the hours
Adjusts the minutes
■The clock is displayed when
The engine switch is in the ACC or ON position.
■When disconnecting and reconnecting battery terminals
The time display will automatically be set to 1:00. ...
