TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Lighting / Headlight Assembly / Installation

Toyota Tacoma (2015-2018) Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the LH and RH sides.
  • The procedure described below is for the LH side.

PROCEDURE

1. INSTALL HEADLIGHT ASSEMBLY

(a) Connect the connectors.

(b) Engage the clamp to install the headlight assembly.

(c) Install the bolt.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

(d) Install the 2 screws.

(e) Remove the protective tape.

2. INSTALL FRONT BUMPER ASSEMBLY

(See page ) ) )

3. ADJUST HEADLIGHT AIMING

(See page Reassembly )

    Related Tacoma materials

    Installation
    INSTALLATION PROCEDURE 1. INSTALL VANE PUMP (a) Install the vane pump assembly with the 2 bolts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} (b) Connect the oil pressure switch connector. NOTICE: Make sure that no oil adheres to the connector. ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY (a) Engage the 2 claws to install the No. 1 stereo jack adapter assembly. 2. INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL (See page ) 3. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (See page ) 4. INSTALL F ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area ...