Toyota Tacoma (2015-2018) Service Manual: Engine

Toyota Tacoma (2015-2018) Service Manual / Maintenance / Engine

General Maintenance

GENERAL MAINTENANCE

CAUTION / NOTICE / HINT

HINT:

Inspect these items when the engine is cold.

PROCEDURE

1. REPLACE CHAIN SUB-ASSEMBLY

HINT:

2TR-FE: See page
2GR-FKS: See page

2. INSPECT DRIVE BELT

HINT:

2TR-FE: See page
2GR-FKS: See page

3. REPLACE SPARK PLUGS

HINT:

2TR-FE: See page
2GR-FKS: See page

4. REPLACE AIR CLEANER FILTER

(a) Replace the air filter with a new one.

5. REPLACE ENGINE OIL AND OIL FILTER

HINT:

2TR-FE: See page
2GR-FKS: See page

6. REPLACE ENGINE COOLANT

HINT:

2TR-FE: See page
2GR-FKS: See page

7. INSPECT RADIATOR FIN

(a) Check that the radiator and condenser are not blocked with leaves, dirt, or insets, and clean the hose connection.

8. INSPECT GASKET IN FUEL TANK CAP

HINT:

2TR-FE: See page
2GR-FKS: See page

9. INSPECT CHARCOAL CANISTER

HINT:

2TR-FE: See page
2GR-FKS: See page

10. INSPECT FUEL LINES, CONNECTIONS AND FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND

(a) Visually check the fuel lines for cracks, leakage, loose connections, deformation or tank band looseness.

11. INSPECT EXHAUST PIPE AND MOUNTING

(a) Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.

Chassis

General Maintenance GENERAL MAINTENANCE PROCEDURE 1. INSPECT STEERING LINKAGE (a) Check the steering wheel free play (See page ). (b) Check the steering linkage for looseness or damage. (1) ...

Inside Vehicle

General Maintenance GENERAL MAINTENANCE CAUTION / NOTICE / HINT Performing these maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or ta ...

Other materials:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals ...

Hazard Warning Switch Circuit
DESCRIPTION The combination meter assembly receives information signals from the telltale light assembly (hazard warning signal switch). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedur ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the C27 and C29 certification ECU (smart key ECU assembly) connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side w ...