Toyota Tacoma (2015-2018) Service Manual: Customize Parameters

Toyota Tacoma (2015-2018) Service Manual / Cruise Control / Lane Departure Alert System / Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE LANE DEPARTURE ALERT SYSTEM

NOTICE:

When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

(a) Customizing with the Multi-information display

(1) Turn the ignition switch to ON.

(2) Enter the following menus: Settings Tab / Settings / Lane Departure Alert Setup

(3) Select the setting by referring to the table below.

(4) Change the settings of the lane departure alert using the steering pad switch assembly.

Lane Departure Alert

Item	Content	Setting	Default
LDA Sensitivity	Timing of lane departure warning	High (graphic display) Standard (graphic display)	Standard
Sway Warning	Vehicle sway warning function	ON/OFF	ON
Sway Warning Sensitivity	Vehicle sway detection sensitivity	High (graphic display) Normal (graphic display) Low (graphic display)	Normal

Operation Check

OPERATION CHECK CHECK LANE DEPARTURE ALERT MAIN SWITCH (a) Check the lane departure alert main switch (steering pad switch assembly) on/off operation. (1) Turn the ignition switch to ON. (2) Con ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials:

Removal
REMOVAL PROCEDURE 1. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY (See page ) 2. REMOVE TURN OVER SPRING SEAT COMPRESSION SPRING (a) Remove the compression spring. 3. REMOVE CLUTCH PEDAL SUB-ASSEMBLY (a) Remove the bolt and nut. ...

USB Device Malfunction (B1585)
DESCRIPTION This DTC is stored when a malfunction occurs in a connected device. DTC No. DTC Detection Condition Trouble Area B1585 USB Device Malfunction Non mass-storage class or incompatible protocol USB device ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY (a) Check that the ignition switch is OFF. (b) Check that the cable is disconnec ...