Toyota Tacoma (2015-2018) Service Manual: Wiper Switch

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Precaution

PRECAUTION 1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. ...

Other materials:

Transmitter ID1 Error (C2141/41-C2144/44)
DESCRIPTION The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressure of each wheel. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measu ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR (a) Check that the ignition switch is off. (b) Check that the battery negative (-) terminal is disconnected. CAUTION: Wait at least 90 seconds after disconnecting the ca ...

Control Module Communication Bus OFF (U0073,U0100,U0114,U0123,U0124,U0126)
DESCRIPTION The skid control ECU (master cylinder solenoid) receives the signals from the ECM, steering angle sensor (spiral cable with sensor sub-assembly), 4 wheel drive control ECU*, and yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. *: ...