Toyota Tacoma (2015-2018) Service Manual: Vehicle Information Not Obtained (C1A02)

Toyota Tacoma (2015-2018) Service Manual / Cruise Control / Dynamic Radar Cruise Control System(for 2tr-fe) / Vehicle Information Not Obtained (C1A02)

DESCRIPTION

When a new millimeter wave radar sensor assembly is installed, it receives vehicle specification information (destination, steering wheel position, 2WD or 4WD, etc.) from the main body ECU (multiplex network body ECU) and stores the information.

DTC C1A02 is stored when the millimeter wave radar sensor assembly cannot store the vehicle specification information from the main body ECU (multiplex network body ECU).

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1A02	Vehicle Information Not Obtained	While the ignition switch is ON and the dynamic radar cruise control system is operating, the millimeter wave radar sensor assembly cannot store the vehicle specification information for approximately 0.1 seconds or more.	Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the millimeter wave radar sensor assembly always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click here
First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.
Click here

PROCEDURE

1.	CHECK FOR DTC (RADAR CRUISE 2)

(a) Clear the DTCs.

Click here (b) Make sure that the DTC detection conditions are met.

(b) Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Wait for 2 seconds or more.

Click here

Result	Proceed to
DTC C1A02 is not output	A
DTC C1A02 is output	B

USE SIMULATION METHOD TO CHECK

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

Communication Error from ECM to VSC (P1631)

DESCRIPTION The ECM sends signals such as A/T information signals, dynamic radar cruise control operation signals, brake operation demand signals, and buzzer operation demand signals to the skid ...

Communication Error from VSC to ECM (P1630)

DESCRIPTION The skid control ECU (brake actuator assembly) sends signals such as cruise control cancel signals and brake demand response signals to the ECM when the dynamic radar cruise control s ...

Other materials:

Garage door opener
The garage door opener can be trained to operate garage doors, gates, entry doors, door locks, home lighting systems, security systems, and other devices. The garage door opener (HomeLink® Universal Transceiver) is manufactured under license from HomeLink®. Training the HomeLink® (for U.S. ...

Do-it-yourself service precautions
If you perform maintenance yourself, be sure to follow the correct procedures as given in these sections. CAUTION The engine compartment contains many mechanisms and fluids that may move suddenly, become hot, or become electrically energized. To avoid death or serious injury observe the ...

Steering Pad Switch Circuit
DESCRIPTION The forward recognition camera receives a lane departure alert switch signal from the steering pad switch assembly. WIRING DIAGRAM for 2TR-FE for 2GR-FKS CAUTION / NOTICE / HINT NOTICE: The vehicle is equipped with a Supplemental Restraint System (SRS) which includes compo ...