PROCEDURE
|
1. |
CHECK MULTI-DISPLAY |
(a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
| NG | |
REMOVE FOREIGN MATTER |
|
|
2. |
CHECK TOUCH PANEL |
(a) Check for foreign matter on the display.
OK:
The display is clean.
| NG | |
CLEAN DISPLAY AND RECHECK TOUCH PANEL |
|
|
3. |
CHECK TOUCH SWITCH (OPERATION CHECK) |
(a) Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation
Check (See page
).
(b) Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
| OK | |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Screen Flicker or Color Distortion
Poor Sound Quality in All Modes (Low Volume)Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL UPPER RADIATOR TANK
(a) Install a new upper radiator tank.
Text in Illustration
*1
Upper Radiator Tank
*2
Core Plate
*a
Correc ...
Other System Malfunction (C1A63)
DESCRIPTION
The millimeter wave radar sensor assembly receives accelerator pedal position
sensor signals from the ECM to determine if the accelerator pedal is being depressed.
If the ECM detects a malfunction in the accelerator pedal position sensor or SFI
system, the millimeter wave radar se ...
Steering Pad Switch Circuit
DESCRIPTION
This circuit sends an operation signal from the steering pad switch assembly
to the navigation receiver assembly.
If there is an open in the circuit, the audio system cannot be operated using
the steering pad switch assembly.
If there is a short in the circuit, the same condition ...