REMOVAL
PROCEDURE
1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
Transmission |
See page |
---|---|
AC60E |
|
AC60F |
|
2. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
(See page )
3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)
6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
7. REMOVE REAR ENGINE OIL SEAL
(a) Using a knife, cut off the lip of the rear engine oil seal. Text in Illustration
|
|
(b) Using a screwdriver, pry out the rear engine oil seal.
NOTICE:
Do not damage the surface of the rear engine oil seal press fit hole or crankshaft.
HINT:
Tape the screwdriver tip before use.
Driver Side Door Entry Lock Function does not Operate
DESCRIPTION
If the entry lock function does not operate for the driver door only, but the
entry unlock function operates, the request code is being transmitted properly from
the driver door. In this case, there may be a problem related to the front door
outside handle assembly LH (lock sensor ...
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK DLC3
(a) The vehicle ECUs use ISO 15765-4 communication protocol. The terminal arrangement
of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
Terminals No. (Symbols)
Terminal Description
Condition
Spe ...
If the shift lever cannot be shifted from P (vehicles with an automatic transmission)
If the shift lever cannot be shifted with your foot on the brake, there may
be a problem with the shift lock system (a system to prevent accidental operation
of the shift lever). Have the vehicle inspected by your Toyota dealer immediately.
The following steps may be used as an emergency measur ...