Toyota Tacoma (2015-2018) Service Manual: Removal

Toyota Tacoma (2015-2018) Service Manual / Seat Belt / Front Seat Inner Belt Assembly / Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here PROCEDURE

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. REMOVE SEAT TRACK COVER

3. REMOVE SEAT TRACK COVER

(a) for Driver Side:

Click here (b) for Front Passenger Side:

(b) for Front Passenger Side:

Click here 4. REMOVE FRONT SEAT ASSEMBLY

4. REMOVE FRONT SEAT ASSEMBLY

(a) for Driver Side:

Click here (b) for Front Passenger Side:

(b) for Front Passenger Side:

Click here 5. REMOVE FRONT SEAT INNER BELT ASSEMBLY

5. REMOVE FRONT SEAT INNER BELT ASSEMBLY

(a) for Driver Side:

(1) Disengage the 3 clamps.

(2) Disconnect the seat position sensor connector.

(3) Remove the nut and front seat inner belt assembly.

(4) Remove the front seat belt anchor plate.

(b) for Front Passenger Side:

(1) Disconnect the connector.

(2) Disengage the 2 clamps.

(3) Remove the nut and front seat inner belt assembly.

(4) Remove the front seat belt anchor plate.

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard resist ...

Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing. Cli ...

Other materials:

Tail Gate Protector
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE TAIL GATE PROTECTOR (a) Using a T30 "TORX" socket wrench, remove the 8 screws. (b) Disengage the 14 claws and 3 guides to remove the tail gate protector ...

Blind Spot Monitor Main Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL (See page ) 2. REMOVE BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY) (a) Disengage the 2 claws to remove the blind spot monitor main switch ...

Reverse Signal Circuit
DESCRIPTION The radio and display receiver assembly*1 or navigation receiver assembly*2 receives a reverse signal from the park/neutral position switch*3 or the back-up light switch assembly*4. *1: w/o Navigation System *2: w/ Navigation System *3: for Automatic Transmission ...