REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
Click here
4. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
Click here
5. REMOVE NO. 1 DOOR TRIM BRACKET
Click here
6. REMOVE FRONT DOOR SERVICE HOLE COVER
Click here
7. REMOVE NO. 2 FRONT DOOR SERVICE HOLE COVER
Click here
8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
Click here
9. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
(a) Put protective tape around the front door glass outer weatherstrip assembly. |
|
(b) Using a screwdriver, disengage the 5 claws to remove the front door glass outer weatherstrip assembly.
Rear Speed Sensor RH Performance (C1411,C1412)
DESCRIPTION
Refer to DTCs C1401 and C1402 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1411
C1412
One of the following conditions is met:
When the vehicle is driven in reverse at a speed of 3 km/h (2
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
If a trouble code is displayed during the DTC check, check the circuit listed
for the code in the table below (proceed to the page listed for that circuit).
1. Occupant Detection ECU
HINT:
When DTC B1650/32 is detected as a result of troubleshooting the Supplement ...
AUTO LSD Indicator Light does not Come ON
DESCRIPTION
The AUTO LSD does not operate even if the VSC OFF switch is pressed under the
following conditions:
The brake system is faulty.
The temperature inside the hydraulic brake booster increases and the
AUTO LSD operation is suspended.
WIRING DIAGRAM
CAUTION / NOTI ...