REMOVAL
PROCEDURE
1. DISCONNECT TRANSMISSION WIRE
(See page )
2. REMOVE VALVE BODY OIL STRAINER ASSEMBLY
(a) Remove the 3 bolts and valve body oil strainer assembly from the transmission valve body assembly. |
|
3. REMOVE TRANSMISSION VALVE BODY ASSEMBLY
(a) Remove the bolt, detent spring cover and detent spring from the transmission valve body assembly. |
|
(b) Remove the 12 bolts and transmission valve body assembly from the automatic transmission case sub-assembly. |
|
4. REMOVE MANUAL VALVE
(a) Remove the manual valve from the transmission valve body assembly. |
|
5. REMOVE TRANSMISSION CASE GASKET
(a) Remove the 2 transmission case gaskets from the automatic transmission case sub-assembly. |
|
Tires
Replace or rotate tires in accordance with maintenance schedules and treadwear.
■ Checking tire
1. New tread
2. Treadwear indicator
3. Worn tread
The location of treadwear indicators is shown by the “TWI” or “
” marks, etc., molded on the sidewall of each tire.
Check spare ti ...
Operation Check
OPERATION CHECK
1. BLIND SPOT MONITOR BEAM AXIS INSPECTION
(a) Procedure to enter Test Mode
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the blind spot monitor main switch assembly (warning canceling switch
assembly) on.
(4) Turn the Techstream on.
(5 ...
Vehicle Speed Sensor "A" No Signal (P050031)
DESCRIPTION
The speed sensor detects the wheel speed and sends the appropriate signals to
the skid control ECU. The skid control ECU converts these wheel speed signals into
a pulse signal and outputs it to the ECM via the combination meter. The ECM determines
the vehicle speed based on the fr ...