DESCRIPTION
This DTC is output when a malfunction is detected due to a short to ground occurring in the differential lock coil drive circuit of the rear differential.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
P17C0 |
Rear Differential Lock Solenoid Circuit Low |
|
|
WIRING DIAGRAM
PROCEDURE
1. |
CHECK DIFFERENTIAL LOCK COIL |
(a) Disconnect the 4 wheel drive control ECU connector.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
|
2. |
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL LOCK COIL) |
(a) Disconnect the F12 4 wheel drive control ECU connector.
(b) Disconnect the D28 differential lock coil connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F12-1 (SL+) or D28-2 (SL+) - Body ground |
Always |
10 kΩ or higher |
F12-5 (SL-) or D28-1 (SL-) - Body ground |
Always |
10 kΩ or higher |
OK |
REPLACE DIFFERENTIAL LOCK COIL |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Brake System (P157800)
DESCRIPTION
This DTC is stored when a malfunction is detected in the vehicle stability control
system.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
P157800
Brake System
While the igni ...
Removal
REMOVAL
PROCEDURE
1. DRAIN DIFFERENTIAL OIL
2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 2WD)
3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD)
4. REMOVE REAR DRIVE PINION NUT
(a) Using SST and a hammer, unstake the nut.
SST: 09930-00010
(b) for BD20:
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REFRIGERANT PRESSURE
(a) This method uses a refrigerant recovery unit set to locate problem areas.
Read the refrigerant pressure when the test conditions are established.
Test conditions:
Temperature at the air inlet with the air recirculation ...