Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table

Toyota Tacoma (2015-2018) Service Manual / Mirror / Power Mirror Control System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Power Mirror Control System

Symptom	Suspected Area	See page
Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch	Outer mirror switch assembly
	Outer rear view mirror assembly LH
	Outer rear view mirror assembly RH
	Wire harness or connector	-
Mirror Heater does not operate with Mirror Heater Switch	Proceed to "Mirror Heater does not Operate with Rear Defogger Switch"

Operation Check

OPERATION CHECK 1. CHECK REMOTE CONTROL MIRROR FUNCTION (a) Turn the ignition switch to ON. (b) With L on the mirror select switch selected, check that the outer rear view mirror assembly LH surf ...

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Automatic Air Conditioning) (See page ) 2. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Manual Air Conditioning) (See page ) ...

Other materials:

Steering Angle Sensor Internal Circuit (C1433)
DESCRIPTION Steering angle sensor (spiral cable with sensor sub-assembly) signals are sent to the skid control ECU (master cylinder solenoid) via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor (spiral cabl ...

Power Window Motor Malfunction (B2311)
DESCRIPTION The power window regulator motor assemblies are operated by the power window regulator master switch assembly, front power window regulator switch assembly RH. The power window regulator motor assemblies have motor, regulator and ECU functions. This DTC is output when the power win ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL BRAKE BOOSTER ACCUMULATOR ASSEMBLY (a) Place the brake booster pump in a vise with a cloth. (b) Install the brake booster accumulator pipe, compression spring and a new O-ring. NOTICE: Ensure that no foreign matter enters the pump. (c) Using a socket wrench ...