Toyota Tacoma (2015-2018) Service Manual: Operation Check
OPERATION CHECK
1. CHECK REMOTE CONTROL MIRROR FUNCTION
(a) Turn the ignition switch to ON.
(b) With L on the mirror select switch selected, check that the outer rear view mirror assembly LH surface moves up, down, left and right normally.
(c) With R on the mirror select switch selected, check that the outer rear view mirror assembly RH surface moves up, down, left and right normally.
2. CHECK MIRROR HEATER FUNCTION
(a) Turn the ignition switch to ON.
(b) Check that pressing the mirror heater switch illuminates the indicator and warms the mirror surfaces.
(c) Check that after approximately 15 minutes, the indicator light turns off and the mirror heater deactivates.
HINT:
There is a timer extension function which can operate the mirror heater system for up to an additional 45 minutes.
System Diagram
SYSTEM DIAGRAM
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are lis ...
Other materials:
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 ULTRASONIC SENSOR
HINT:
Use the same procedure for both sides.
(a) Engage the 4 claws to install the 4 No. 1 ultrasonic sensors as shown in
the illustration.
2. INSTALL REAR BUMPER EXTENSION LH (w/ Towing Package)
(See page )
3. INSTALL REAR BUMPE ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Navigation System
DTC Code
Detection Item
See page
B1324
Lost Communication with Meter
B1532
LVDS Signal Malfunction (from Extension Module)
...
