Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Rear Airbag Sensor(for Double Cab) / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT REAR AIRBAG SENSOR (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check (See page 2. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag has ).

2. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag has not Deployed)

(a) Perform a diagnostic system check (See page (b) When the quarter panel of the vehicle or its area is damaged, check if there ).

(b) When the quarter panel of the vehicle or its area is damaged, check if there is any damage to the rear airbag sensor. If there are any defects as mentioned below, replace the rear airbag sensor with a new one:

Cracks, dents or chips on the sensor housing.
Cracks or other damage to the connector.
Peeling off of the label or damage to the serial number.

CAUTION:

For removal and installation procedures of the rear airbag sensor. Be sure to following the correct procedure.

3. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision)

(a) Replace the rear airbag sensor.

CAUTION:

For removal and installation procedures of the rear airbag sensor. Be sure to follow the correct procedure.

HINT:

The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag assembly has deployed.

Components

COMPONENTS ILLUSTRATION ...

Removal

REMOVAL CAUTION / NOTICE / HINT PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). NOTICE: After turning the ignition switch off, waiting tim ...

Other materials:

Yaw Rate Sensor Malfunction (C1436)
DESCRIPTION The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration (airbag sensor assembly) via the CAN communication system. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle's condition using 2 ...

Lost Communication with ECM (C1437)
DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the ECM via the CAN communication system. DTC No. Detection Item DTC Detection Condition Trouble Area C1437 Lost Communication with ECM ...

Combination Meter
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable fro ...