Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FRONT AXLE HUB BEARING

(a) Remove the front wheel.

(a) Remove the front wheel.

(b) for 4WD:

(1) Remove the front axle hub grease cap (See page (c) Remove the front disc brake caliper (See page (c) Remove the front disc brake caliper (See page ).

(c) Remove the front disc brake caliper (See page (d) Remove the front disc. (d) Remove the front disc. ).

(d) Remove the front disc.

(e) Inspect the axle hub backlash.

(1) Using a dial indicator, check the backlash near the center of the axle hub.

Maximum:

0.05 mm (0.0020 in.)

If the backlash exceeds the maximum, replace the bearing.

(f) Inspect the axle hub deviation.

(1) Using a dial indicator, check the distortion of the surface of the axle hub.

Maximum:

0.05 mm (0.0020 in.)

If the deviation exceeds the maximum, replace the bearing.

2. INSPECT REAR AXLE HUB BEARING

(a) Remove the rear wheel.

(a) Remove the rear wheel.

(b) Remove the rear brake drum (See page (c) Inspect the axle shaft backlash. ).

(c) Inspect the axle shaft backlash.

(1) Using a dial indicator, check the backlash near the center of the axle shaft.

Maximum:

0.05 mm (0.0020 in.)

If the backlash exceeds the maximum, replace the bearing.

(d) Inspect the axle shaft deviation.

(1) Using a dial indicator, check the distortion of the surface of the axle shaft.

Maximum:

0.05 mm (0.0020 in.)

If the deviation exceeds the maximum, replace the bearing.

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order ...

Front Axle Hub
...

Other materials:

Mechanical System Tests
MECHANICAL SYSTEM TESTS 1. STALL SPEED TEST HINT: This test is to check the overall performance of the engine and transmission. CAUTION: This test should be done on a paved surface (a surface that is not slippery). To ensure safety, perform this test in an open and level area tha ...

Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Radar Cruise 1*1 / Trouble Codes. (e) Enter the following menus: Powertrain / Radar Cruise 2*2 / Trouble Codes. (f) C ...

Precaution
PRECAUTION 1. CAUTION REGARDING INTERFERENCE WITH ELECTRONIC DEVICES CAUTION: People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should keep away from the smart key system antennas. The radio waves ma ...

В© 2011-2024 Copyright www.ttguide.net