Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Axle System

Symptom

Suspected Area

See page

Wander/pulls

Tires (Worn or improperly inflated)

Front wheel alignment (Incorrect)

Hub bearings (Loosen or worn)

Steering gear (Out of adjustment or broken)

-

Front wheel shimmy

Tires (Worn or improperly inflated)

Wheels (Out of balance)

Front shock absorber (Worn out)

Front wheel alignment (Incorrect)

Upper ball joints (Worn)

Lower ball joints (Worn)

Hub bearings (Loosen or worn)

Steering gear (Out of adjustment or broken)

-

Rear wheel shimmy

Tires (Worn or improperly inflated)

Wheels (Out of balance)

Rear shock absorber (Worn out)

Hub bearings (Loosen or worn)

Axle System
...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FRONT AXLE HUB BEARING (a) Remove the front wheel. (b) for 4WD: (1) Remove the front axle hub grease cap (See page ). (c) Remove the front disc br ...

Other materials:

Unable to Lock Steering Wheel
DESCRIPTION The steering lock actuator assembly activates the steering lock motor and moves the lock bar into the steering column to lock the steering. When the steering lock is operating, the steering may not lock when the lock bar is not aligned with the lock hole of the steering column. In ...

Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
DESCRIPTION When the engine is running or the ignition switch is ON, the front power window regulator motor assembly RH is operated by the front power window regulator switch assembly RH. The front power window regulator motor assembly RH has motor, regulator, and ECU functions. HINT: If th ...

Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL PUMP ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 0.45 to 0 ...

© 2011-2024 Copyright www.ttguide.net