INSTALLATION
PROCEDURE
1. INSTALL BRAKE PEDAL PAD
(a) Install the brake pedal pad onto the brake pedal.
2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
(a) Install the brake pedal support assembly with 4 nuts.
Torque:
14 N·m {145 kgf·cm, 10 ft·lbf}
(b) Connect the stop light switch connector to the stop light switch.
(c) Install the bolt onto the reinforcement. Torque: 19 N·m {189 kgf·cm, 14 ft·lbf} |
|
3. INSTALL MASTER CYLINDER PUSH ROD CLEVIS
(a) Apply lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.
(b) Install the push rod clevis onto the brake pedal lever with the push rod pin and a new clip.
4. INSPECT BRAKE PEDAL HEIGHT
Click here
5. INSPECT PEDAL FREE PLAY
Click here
6. INSPECT PEDAL RESERVE DISTANCE
Click here
7. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
8. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL REAR AXLE HUB BOLT
(a) Install a new deflector gasket and deflector onto the rear axle shaft.
HINT:
Align the 2 notches.
(b) Install the 6 bolts through the axle hub.
...
Microphone Circuit between Microphone and Radio Receiver
DESCRIPTION
The navigation receiver assembly and telephone microphone assembly are connected
to each other using the microphone connection detection signal lines.
Using this circuit, the navigation receiver assembly sends power to the telephone
microphone assembly and the telephone microphone ...
Disassembly
DISASSEMBLY
PROCEDURE
1. INSPECT 3RD GEAR THRUST CLEARANCE
(a) Using a dial indicator, measure the 3rd gear thrust clearance.
Standard clearance:
0.200 to 0.490 mm (0.0079 to 0.0192 in.)
If the clearance is outside the specification, replace the 3rd gear,
thrust washer, c ...