Toyota Tacoma (2015-2018) Service Manual: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
(a) Install the front No. 1 speaker assembly with the 4 screws.
NOTICE:
Do not touch the cone part of the front No. 1 speaker assembly.
(b) Connect the connector.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
(See page .gif)
)
3. INSTALL FRONT ARMREST BASE UPPER PANEL SUB-ASSEMBLY
(See page
)
4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
(See page
)
5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
(See page
)
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (w/o Amplifier Box Speaker Assembly)
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
...
Other materials:
Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT DETECTION ECU
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnected from the battery negative (-) terminal
is disconnected.
CAUTION:
After removing the cable from the terminal, wait for at least 90 seconds before
star ...
Communication Error from ECM to VSC Invalid Serial Data Received (P163181)
DESCRIPTION
The ECM sends signals such as dynamic radar cruise control operation signals,
brake operation demand signals and buzzer operation demand signals to the skid control
ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2
when the dynamic radar cruise contr ...
Precaution
PRECAUTION
1. PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal,
initialize the following systems after the cable is reconnected (See page
).
Perform the Reset Memory procedures (A/T initialization) after replacing
the automatic transmi ...
