INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Support the steering pad with one hand.
(d) Connect the horn terminal.
(e) Connect the 2 airbag connectors. NOTICE: When connecting any airbag connector, take care not to damage the airbag wire harness. |
|
(f) Push in the 2 airbag connector locks to install the 2 airbag connectors.
(g) Install the steering pad.
(h) Using a T30 "TORX" socket wrench, tighten the 2 screws. Torque: 8.8 N·m {90 kgf·cm, 78 in·lbf} |
|
2. INSTALL LOWER NO. 2 STEERING WHEEL COVER
(a) Engage the guide and claw to install the lower No. 2 steering wheel cover.
3. INSTALL LOWER NO. 3 STEERING WHEEL COVER
(a) Engage the guide and claw to install the lower No. 3 steering wheel cover.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
5. INSPECT STEERING PAD
(a) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
(b) Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
6. INSPECT SRS WARNING LIGHT
(See page )
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Perform the following procedure to troubleshoot the dynamic radar cruise
control system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Front Airbag Sensor RH Circuit Malfunction (B1610/13)
DESCRIPTION
The front airbag sensor RH consists of parts such as the diagnostic circuit and
the frontal detection sensor.
When the airbag sensor assembly receives signals from the frontal deceleration
sensor, it determines whether or not the SRS should be activated.
DTC B1610/13 is set when a ...
Distance Control Switch Circuit
DESCRIPTION
The distance control switch is used to set the distance for vehicle-to-vehicle
distance control mode. The distance control switch is installed in the steering
pad switch assembly. The vehicle-to-vehicle distance set value can be changed by
operating the steering pad switch assembl ...