Toyota Tacoma (2015-2018) Service Manual: Installation

Toyota Tacoma (2015-2018) Service Manual / Vf2cm Transfer / 4wd Control Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSFER POSITION SWITCH

(a) Attach the 2 claws to install the transfer position switch.

2. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

(See page 3. INSTALL INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System) )

3. INSTALL INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)

(See page Touch Select 2-4 And High-low System )

Removal

REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) (See page ) 2. REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System) (See page ...

Touch Select 2-4 And High-low System

...

Other materials:

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line ECM Millimeter Wave Radar Sensor Assembly Cruise control operation signal Accelerator pedal idle position signal Accel overr ...

Ptc Heater Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (See page ) 2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY 3. REMOVE AIR DUCT ASSEMBLY 4. REMOVE QUICK HEATER ASSEMBLY (a) Disconnect the connector. ...