Toyota Tacoma (2015-2018) Service Manual: Inspection

Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Rear Door Speaker(for Double Cab) / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR SPEAKER ASSEMBLY (w/o Amplifier Box Speaker Assembly)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection	Condition	Specified Condition
1 - 2	Always	3.2 to 4.8 Ω

If the result is not as specified, replace the rear speaker assembly.

Text in Illustration

*a	Component without harness connected (Rear Speaker Assembly)

2. INSPECT REAR SPEAKER ASSEMBLY (w/ Amplifier Box Speaker Assembly)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection	Condition	Specified Condition
1 - 2	Always	1.5 to 2.1 Ω

If the result is not as specified, replace the rear speaker assembly.

Text in Illustration

*a	Component without harness connected (Rear Speaker Assembly)

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR DOOR FRAME GARNISH ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR SPEAKER ASSEM ...

Other materials:

Operation Check
OPERATION CHECK 1. OPERATION DESCRIPTION (a) Push-button start function: (1) When the electrical key transmitter sub-assembly is in a detection area inside the vehicle and the brake pedal is depressed, the engine is started by pressing the engine switch. (2) When the electrical key transmitt ...

Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL PUMP (a) Inspect the resistance of the fuel pump. (1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without harness connected (Fuel Pump) ...

VSC OFF Switch Circuit
DESCRIPTION The skid control ECU assembly is connected to the combination meter assembly via CAN communication. Pressing the VSC OFF switch turns off TRAC operation, and pressing and holding this switch turns off TRAC and VSC operation. If TRAC and VSC operations are turned off, the TRAC OFF ...