Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a |
Component without harness connected (Engine Switch) |
- |
- |
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
5 (SS1) - 6 (GND) |
Not pushed |
10 kΩ or higher |
1 (SS2) - 6 (GND) |
||
5 (SS1) - 6 (GND) |
Pushed |
Below 1 Ω |
1 (SS2) - 6 (GND) |
If the result is not as specified, replace the engine switch.
(b) Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.
Text in Illustration
*a |
Indicator Light |
*b |
Component without harness connected (Engine Switch) |
OK:
Measurement Condition |
Specified Condition |
---|---|
Battery positive (+) → Terminal 9 (SWIL) Battery negative (-) → Terminal 6 (GND) |
Illuminates |
HINT:
If the result is not as specified, replace the engine switch.
Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE SWITCH
(a) Engage the 2 claws and install the engine switch to the air conditioning control assembly.
2. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
(See page )
Removal
REMOVAL
PROCEDURE
1. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Seepage
2. REMOVE ENGINE SWITCH
(a) Disengage the 2 claws and remove the engine switch from the air conditioning control assembly. |
|
Automatic High Beam System (B124B)
DESCRIPTION
The main body ECU (multiplex network body ECU) determines the status of the automatic
high beam system based on the automatic high beam system signal from the forward
recognition camera.
DTC No.
Detection Item
DTC Detection Condition
Trou ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the rear view monitor system.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
CUSTOMER PROBLEM ANALYSIS
...
Transmission Range Sensor "A" Circuit Open (P070513,P070562)
DESCRIPTION
The park/neutral position switch detects the shift lever position and sends signals
to the ECM.
DTC No.
DTC Detection Condition
Trouble Area
SAE
P070513
All of the following signals are OFF simultaneously for 60 ...