CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the rear view monitor system.
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
|
3. |
CHECK DTC |
(a) Check for DTCs and note any codes that are output.
Click here
(b) Clear the DTCs.
Click here
(c) Recheck for DTCs.
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
4. |
PROBLEM SYMPTOM CONFIRMATION |
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
Result |
Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
B |
GO TO STEP 7 |
|
6. |
BASED ON PROBLEM SYMPTOM, PERFORM TROUBLESHOOTING BELOW |
(a) Terminals of ECU.
Click here
|
7. |
ADJUST, REPAIR OR REPLACE |
|
8. |
CONFIRMATION TEST |
NEXT |
END |
Illumination for Panel Switch does not Come on with Tail Switch ON
PROCEDURE
1.
CHECK VEHICLE SIGNAL (OPERATION CHECK)
(a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal
in Operation Check (See page ).
(b) Check that the display changes between ON and OFF according to the light
control ...
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
*A
w/ Seat Heater System
-
-
*1
FRONT SEAT CUSHION HEATER ASSEMBLY
*2
FRONT SEATBACK HEATER ASSEMBLY
...
Oil Pressure Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disengage the clamp and disconnect the engine oil pressure switch
connector.
(b) Using a 24 mm deep socket ...