PROCEDURE
1. |
CHECK IMAGE QUALITY SETTING |
(a) Display the "Display Settings" screen.
(b) Turn the light control switch to the tail or head position.
(c) Check if "Day Mode" on the display adjustment screen is on.
OK:
"Day Mode" setting is off
NG |
TURN "Day Mode" SETTING OFF |
|
2. |
CHECK VEHICLE SIGNAL (OPERATION CHECK) |
(a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (See page ). |
|
(b) Check that the display changes between ON and OFF according to the light control switch operation.
OK:
Light Control Switch |
Display |
---|---|
Tail or head |
ON |
Off |
OFF |
HINT:
The display is updated once per second. It is normal for the display to lag behind the actual switch operation.
OK |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
System Description
SYSTEM DESCRIPTION
1. UNLOCK OPERATION CONDITIONS FOR STEERING LOCK
(a) When the following condition is met, the unlock operation is performed.
The engine switch is on (ACC) or on (IG).
HINT:
When the engine switch is turned on (ACC) or on (IG) and the key and
certification ECU ( ...
Power outlet (120 VAC)∗
The power outlet can be used for electrical appliances.
Main switch
To use the power outlet, turn on the main switch.
The power supply starts a few seconds after the main switch is pressed.
Power outlet socket
Maximum available capacity of the power outlet
■ While the vehicle is being ...
Operation Check
OPERATION CHECK
1. CHECK INTERMITTENT CONTROL FUNCTION (w/ Intermittent Time Adjustment Switch)
(a) Turn the ignition switch to ON.
(b) Turn the windshield wiper switch assembly to the INT position.
(c) Check that the intermittent operation interval can be adjusted from approximately
1.6 to 10 ...