PROCEDURE
1. |
CHECK VEHICLE SIGNAL (OPERATION CHECK) |
(a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (See page ).
(b) Check that the display changes between ON and OFF according to the light control switch operation.
OK:
Light Control Switch |
Display |
---|---|
Tail or head |
ON |
Off |
OFF |
HINT:
This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
OK |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Removal
REMOVAL
PROCEDURE
1. TABLE OF BOLT, SCREW AND NUT
HINT:
All bolts, screws and nuts relevant to installing and removing the instrument
panel are shown along with their alphabetic codes in the table below.
2. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be requ ...
Rear Occupant Classification Sensor RH Collision Detection (B1788)
DESCRIPTION
DTC B1788 is set when the occupant detection ECU receives a collision detection
signal, which is sent by the occupant classification sensor rear RH when an accident
occurs.
DTC B1788 is also set when the front seat with adjuster frame assembly RH is
subjected to a strong impact, ...
Clutch Release Cylinder(for Rc62f)
Components
COMPONENTS
ILLUSTRATION
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE CLUTCH RELEASE CYLINDER KIT
(a) Remove the boot from the cylinder body.
(b) Remove the push rod from the boot.
(c) Using compressed air, remove the piston together with the spring
from the cy ...