Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart

Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Starting / Smart Key System(for Start Function) / Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Smart Key System (for Start Function)

DTC Code	Detection Item	See page
B2271	Ignition Hold Monitor Malfunction
B2274	ACC Monitor Malfunction
B2277	Detecting Vehicle Submersion
B2282	Vehicle Speed Signal Malfunction
B2283	Vehicle Speed Sensor Malfunction
B2284	Brake Signal Malfunction
B2285	Steering Lock Position Signal Circuit Malfunction
B2286	Runnable Signal Malfunction
P0335	Crankshaft Position Sensor Circuit Malfunction (NE Signal)
U0100	Lost Communication with ECM / PCM
U0140	Lost Communication with Main Body ECU
U0142	Lost Communication with Main Body ECU
U0155	Lost Communication with Combination Meter
U1117	Lost Communication with Accessory Gateway

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Runnable Signal Malfunction (B2286,P0335)

DESCRIPTION These DTCs are stored when the engine speed signal sent by the ECM via direct line and the engine speed signal sent via CAN communication do not match. HINT: When the cable is disconn ...

Other materials:

Inside Vehicle
General Maintenance GENERAL MAINTENANCE CAUTION / NOTICE / HINT Performing these maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY (a) Insert the 6 hooks, install 7 new bolts, 2 new clips (A) with pins and 2 ...

Operation Check
OPERATION CHECK CHECK PRE-COLLISION SYSTEM SETTING (a) Turn the ignition switch to ON. (b) Operate the steering pad switch assembly to change the setting of PCS on the multi-information display to "On" and check that the pre-collision system turns on. HINT: When the ignition switc ...