Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Air Conditioning System|
DTC Code |
Detection Item |
Memory |
See page |
|---|---|---|---|
|
B1411/11 |
Room Temperature Sensor Circuit |
Memorized (4 seconds or more) |
|
|
B1412/12 |
Ambient Temperature Sensor Circuit |
Memorized (4 seconds or more) |
|
|
B1413/13 |
Evaporator Temperature Sensor Circuit |
Memorized (4 seconds or more) |
|
|
B1422/22 |
Compressor Lock Sensor Circuit |
Memorized (3 seconds or more) |
|
|
B1423/23 |
Pressure Sensor Circuit |
- |
|
|
B1431/31 |
Air Mix Damper Position Sensor Circuit (Passenger Side) |
Memorized (4 seconds or more) |
|
|
B1432/32 |
Air Inlet Damper Position Sensor Circuit |
Memorized (4 seconds or more) |
|
|
B1433/33 |
Air Outlet Damper Position Sensor Circuit |
Memorized (4 seconds or more) |
|
|
B1436/36 |
Air Mix Damper Position Sensor Circuit (Driver Side) |
Memorized (4 seconds or more) |
|
|
B1441/41 |
Air Mix Damper Control Servo Motor Circuit (Passenger Side) |
Memorized (16 seconds or more) |
|
|
B1442/42 |
Air Inlet Damper Control Servo Motor Circuit |
Memorized (16 seconds or more) |
|
|
B1443/43 |
Air Outlet Damper Control Servo Motor Circuit |
Memorized (16 seconds or more) |
|
|
B1446/46 |
Air Mix Damper Control Servo Motor Circuit (Driver Side) |
Memorized (16 seconds or more) |
|
|
B14B2 |
Lost Communication with Front Panel LIN |
Memorized (10 seconds or more) |
|
|
U0100 |
Lost Communication with ECM |
- |
|
|
U0142 |
Lost Communication with Main Body ECU |
- |
|
|
U0155 |
Lost Communication with Combination Meter |
- |
|
.gif)
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. T ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electri ...
Other materials:
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
(See page
)
2. REMOVE HEADLIGHT ASSEMBLY
(a) Apply protective tape around the headlight ...
Steering Angle Sensor Zero Point Malfunction (C1290)
DESCRIPTION
The skid control ECU (brake actuator assembly) acquires steering angle sensor
zero point every time the ignition switch is turned ON and the vehicle is driven
at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the
previous zero point.
If front wheel alig ...
Distance Control Switch Circuit
DESCRIPTION
The distance control switch is used to set the distance for vehicle-to-vehicle
distance control mode. The distance control switch is installed in the steering
pad switch assembly. The vehicle-to-vehicle distance set value can be changed by
operating the steering pad switch assembl ...
