DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is displayed during the DTC check, inspect the trouble area for that code. For details of each code, refer to the relevant page listed under respective "See page" in the DTC chart.
Tire Pressure Warning ECU and Receiver
DTC Code |
Detection Item |
See page |
---|---|---|
C2111/11 |
Transmitter ID1 Operation Stop |
|
C2112/12 |
Transmitter ID2 Operation Stop |
|
C2113/13 |
Transmitter ID3 Operation Stop |
|
C2114/14 |
Transmitter ID4 Operation Stop |
|
C2121/21 |
No Signal from Transmitter ID1 |
|
C2122/22 |
No Signal from Transmitter ID2 |
|
C2123/23 |
No Signal from Transmitter ID3 |
|
C2124/24 |
No Signal from Transmitter ID4 in Main Mode |
|
C2126/26 |
Transmitter ID not Received in Main Mode |
|
C2141/41 |
Transmitter ID1 Error |
|
C2142/42 |
Transmitter ID2 Error |
|
C2143/43 |
Transmitter ID3 Error |
|
C2144/44 |
Transmitter ID4 Error |
|
C2171/71 |
Transmitter ID not Registered |
|
C2176/76 |
Receiver Error |
|
C2177/77 |
Initialization not Completed |
|
C2179/79 |
Tire Pressure Monitor ECU Communication Stop |
|
C2181/81 |
Transmitter ID1 not Received (Test Mode DTC) |
|
C2182/82 |
Transmitter ID2 not Received (Test Mode DTC) |
|
C2183/83 |
Transmitter ID3 not Received (Test Mode DTC) |
|
C2184/84 |
Transmitter ID4 not Received (Test Mode DTC) |
|
C2198/98 |
Initialization Switch (for Test Mode DTC) |
|
U0129/29* |
Lost Communication with Brake System Control Module |
|
*: w/ Tire Inflation Pressure Display Function
Main Body ECU (Multiplex Network Body ECU)
DTC Code |
Detection Item |
See page |
---|---|---|
B1247 |
Tire Pressure Monitor Receiver Communication Stop |
|
Rear Door(for Access Cab)
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Use the same procedures for both the LH and RH sides.
The procedure described below is for the LH side.
Centering bolts are used to mount the door hinge to the vehicle body
and door. The door cannot be adjusted with the ce ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT SEATBACK HEATER ASSEMBLY
(a) Set the front seatback heater assembly with the name stamp side facing the
front seatback cover.
(b) Install the front seatback heater assembly with 14 new tag pins.
2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER (for Front P ...
Installation
INSTALLATION
PROCEDURE
1. SET NO. 1 CYLINDER TO TDC/COMPRESSION
2. INSTALL CAMSHAFT TIMING GEAR BOLT
NOTICE:
There are different types of camshaft timing gear bolts. Make sure to check the
identification mark to determine the tightening torque.
*a
Identification Ma ...