Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Differential System (w/ Differential Lock)|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
P163B |
4WD ECU Malfunction |
|
|
P17BB |
Rear Differential Lock Position SW Stuck OFF |
|
|
P17BC |
Rear Differential Lock Position SW Stuck ON |
|
|
P17C0 |
Rear Differential Lock Solenoid Circuit Low |
|
|
P17C1 |
Rear Differential Lock Solenoid Circuit High |
|
|
P17CC |
Rear Differential Lock Control SW Stuck ON |
|
|
U0122 |
Lost Communication with Vehicle Dynamics Control Module |
|
|
U0416 |
Invalid Data Received from Vehicle Dynamics Control Module |
|
.gif)
Data List / Active Test
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether ...
Invalid Data Received from Vehicle Dynamics Control Module (U0416)
DESCRIPTION
This DTC is detected if a wheel speed malfunction signal is sent from the skid
control ECU (brake actuator assembly).
DTC No.
Detection Item
DTC Detect ...
Other materials:
Installation
INSTALLATION
PROCEDURE
1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY (with Grease Fitting)
HINT:
When replacing the spider bearing, make sure that the grease fitting assembly
hole is facing in the direction shown in the illustration.
Text in Illustration
*1
No. 1 Grease Fi ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT LOWER ARM BUSH NO. 1
(a) Install a new lower arm bush using SST, a press and steel plate.
SST: 09631-12090
SST: 09631-32020
NOTICE:
Push the lower arm bush in until the bush positioning protrusions come to the
positions shown in the illustration.
2. ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT COUNTER GEAR
(a) Using a dial indicator and 2 V-blocks, measure the counter gear runout.
Maximum runout:
0.03 mm (0.00118 in.)
If the runout is more than the maximum, replace the counter gear.
HINT:
Measure the 3 areas shown in the illust ...
