Toyota Tacoma (2015-2018) Service Manual: Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
FUNCTION OF WARNING INDICATOR AND MESSAGE
(a) If the lane departure alert system is not functioning properly, the driver is warned by the lane departure alert indicator and multi-information display warning message on the combination meter assembly.
|
Master Warning Indicator |
Warning Message |
Detail |
DTC |
Lane Departure Alert Indicator |
|---|---|---|---|---|
|
Illuminated |
Lane Departure Alert Malfunction Visit Your Dealer |
Lane departure alert system is malfunctioning |
Stored |
Illuminates (yellow) |
|
Not illuminated |
Forward Camera Unavailable |
Forward recognition camera temporarily malfunctioning
|
Not stored |
Illuminates (yellow) |
|
Illuminated |
Forward Camera System Unavailable Clean Windshield |
Forward recognition camera view is unclear |
Not stored |
Illuminates (yellow) |
|
Lane Departure Alert Indicator |
Status |
|---|---|
|
Illuminates (yellow) |
The lane departure alert system is malfunctioning or temporarily disabled |
|
Blinks (yellow) |
Lane departure warning function is operating |
|
Illuminates (green) |
Lane departure alert system is operating |
|
Not illuminated |
Lane departure alert system are not operating |
Utility
UTILITY
NOTICE:
If the forward recognition camera has been replaced due to a malfunction in the
lane departure alert system, be sure to perform Recognition Camera/Target Position
Memory and Opti ...
Terminals Of Ecu
TERMINALS OF ECU
FORWARD RECOGNITION CAMERA
NOTICE:
DTCs may be output when connectors are disconnected during inspection.
Therefore, be sure to clear the DTCs using the Techstream once ...
Other materials:
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
(a) Apply MP grease to a new spider and spider bearing.
(b) Fit the spider into the flange yoke.
(c) Measure dimension A between the snap ring grooves.
...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page
).
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore, make sure to read the
...
Cellular Phone cannot Send/Receive
PROCEDURE
1.
CHECK "Bluetooth" SETTINGS
(a) Check if the cellular phone is registered as a connected device and the "Bluetooth"
settings are correct.
OK:
The cellular phone is registered as a connected device and "Bluetooth" settin ...
