DESCRIPTION
This DTC is stored when a malfunction in the water submersion detection circuit in the certification ECU (smart key ECU assembly) is detected.
HINT:
When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.
DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
---|---|---|---|
B2277 |
The water submersion detection circuit in the certification ECU (smart key ECU assembly) detects water submersion (1- trip detection logic*). |
|
Wait 300 seconds after connecting the cable to the negative (-) battery terminal. |
Vehicle Condition when Malfunction Detected |
Fail-safe Function when Malfunction Detected |
---|---|
The engine switch cannot be turned off and the engine cannot be started. |
- |
CAUTION / NOTICE / HINT
NOTICE:
Click here
Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
DTC |
Data List Item |
Active Test Item |
---|---|---|
B2277 |
- |
- |
HINT:
Before proceeding with troubleshooting, check if there are any signs of water damage to the certification ECU (smart key ECU assembly). If there are any signs of water damage, replace the certification ECU (smart key ECU assembly) and take measures against the cause of the water damage.
PROCEDURE
1. |
CHECK WATER INTRUSION |
(a) Check that the certification ECU (smart key ECU assembly), its surrounding area and wire harnesses have no signs of water intrusion.
Result
Result |
Proceed to |
---|---|
No sign of water intrusion found |
A |
Signs of water intrusion found |
B |
A |
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
B |
TAKE MEASURES FOR WATER INTRUSION AND REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Ptc Heater Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
(See page )
2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY
3. REMOVE AIR DUCT ASSEMBLY
4. REMOVE QUICK HEATER ASSEMBLY
(a) Disconnect the connector.
...
System Description
SYSTEM DESCRIPTION
1. SYSTEM DESCRIPTION
HINT:
The skid control ECU is built into the hydraulic brake booster.
(a) ABS (Anti-lock Brake System)
The ABS helps prevent the wheels from locking when the brakes are applied firmly
or when braking on a slippery surface.
(b) Multi-terrain Anti-lock ...
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Double Cab
*B
for Access Cab
*C
w/ Back Door Power Window
-
-
*1
NO. 1 BACK PANEL RELAY
*2
NO. 2 BACK PANEL RELAY
...