DESCRIPTION
The main body ECU (multiplex network body ECU) detects a high beam headlight illumination request signal of the automatic high beam system from the forward recognition camera
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
B124C |
Automatic High Beam Camera |
Malfunction in forward recognition camera |
Forward recognition camera system |
WIRING DIAGRAM
PROCEDURE
1. |
CHECK FORWARD RECOGNITION CAMERA SYSTEM |
(a) Check the forward recognition camera system.
Click here
Proceed to |
---|
NEXT |
NEXT |
END |
Power Source Mode does not Change to ON (IG)
DESCRIPTION
If the engine switch is pressed with the electrical key transmitter sub-assembly
in the cabin, the certification ECU (smart key ECU assembly) receives a signal and
changes the power source mode.
HINT:
When the cable is disconnected and reconnected to the negative (-) battery termi ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Remove SST from the extension housing.
(b) Install the propeller shaft to the extension housing.
(c) Completely remove any oil or the like and clean the contact surfaces of the
propeller shaft flange and diff ...
Low Output Signal of Front Speed Sensor RH (Test Mode DTC) (C1271,C1272,C1401,C1402)
DESCRIPTION
The speed sensor detects the wheel speed and sends the appropriate signals to
the skid control ECU (master cylinder solenoid). These signals are used for brake
control.
The speed sensor rotors have rows of alternating N and S magnetic poles and their
magnetic fields change when t ...