Toyota Tacoma (2015-2018) Service Manual: System Diagram
SYSTEM DIAGRAM
Component
Outline
Engine switch
Transponder key amplifier
Turns on the power and starts the engine.
Contains a built-in transponder key amplifier to start the engine
when the key does not operate properly due to a depleted battery
or wave interference.
Certification ECU (smart key ECU assembly)
Changes the power source mode by operating the ACC and IG relays.
Controls starting by operating the starter relay.
Performs key verification.
Controls the electrical key antenna (outside), electrical key
antenna (indoor) and door lock/unlock sensor.
Outputs a signal indicating that the engine has started to the
certification ECU (smart key ECU assembly) when starting the engine.
Steering lock ECU (steering lock actuator or UPR bracket assembly)
Receives command signals from the certification ECU (smart key
ECU assembly) and activates the steering lock ECU (steering lock
actuator or UPR bracket assembly).
Records codes for smart verification.
Combination meter assembly
Operates various warnings (messages on the multi-information
display, sounding of the buzzer in the combination meter, blinking
or illumination of the smart warning light) according to the command
signals from the certification ECU (smart key ECU assembly).
Displays information or operates LED when the smart key system
has a malfunction.
Outputs a vehicle speed signal to the main body ECU (multiplex
network body ECU).
IG, ACC relay
Turns on/off according to the certification ECU (smart key ECU) and provides
power to each system.
Stop light switch assembly
Detects that the brake pedal has been depressed (switch is on) and outputs
a signal to the certification ECU (smart key ECU assembly).
Sends the request code from the certification ECU (smart key ECU assembly)
and forms the vehicle interior detection area.
Electrical key and TPMS receiver assembly
Receives the smart key system code/wireless code sent from the key and
sends it to the certification ECU (smart key ECU assembly).
Electrical key transmitter sub-assembly
Sends the ID code upon receiving a request signal.
Related Tacoma materials
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an OBD II scan
tool (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector
3) of the vehicle. Various data in the vehicle ECM (Engine Control Module) can be
then read.
(b) ...
Components
COMPONENTS
ILLUSTRATION
HINT:
The following specifications are for BD22A (w/o Differential Lock). BD22A differentials
are equipped with M10 rear differential carrier to rear axel housing fasteners.
ILLUSTRATION
ILLUSTRATION ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
Text in Illustration
*a
Object Exceeding Weight Limit of Transmission Jack
Be sure to perform this procedure with several people as the rear differential
carrier ...