TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Park Assist / Monitoring / Blind Spot Monitor System / Slave Module Horizontal Axis Misalignment (C1AC2)

Toyota Tacoma (2015-2018) Service Manual: Slave Module Horizontal Axis Misalignment (C1AC2)

DESCRIPTION

This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.

HINT:

If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch assembly (warning canceling switch assembly) on, the blind spot monitor system may store this DTC by mistake.

DTC Code

DTC Detection Condition

Trouble Area

C1AC2

When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated.

Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

NOTICE:

  • When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.
  • If the bumper is damaged or the vehicle has a history of body repair, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor sensor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

    Click here If the visual inspection finds a problem, check the installation condition

    If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

PROCEDURE

1.

CHECK INSTALLATION CONDITION

(a) Check the installation condition of the blind spot monitor sensor RH (See page HINT: HINT: ).

HINT:

Take the appropriate action in accordance with the result.

NEXT

2.

PERFORM BEAM AXIS CONFIRMATION

(a) Install the rear bumper.

  • w/ Towing Package (See page w/o Towing Package (See page ) )
  • w/o Towing Package (See page )

(b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (See page OK: OK: ).

OK:

Blind Spot Monitor Beam Axis Confirmation performs normally.

OK

END
NG

REPLACE BLIND SPOT MONITOR SENSOR RH

    Related Tacoma materials

    Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE FOG LIGHT BULB (a) Turn the fog light bulb in the direction indicated by the arrow in the illust ...

    Power windows*
    The power windows can be opened/closed using the following switches. Driver’s power window switches Closing Opening One-touch opening (driver’s window only)* *: To stop the window partway, operate the switch in the opposite direction. Front and rear passenger’s power window swi ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page ). If the side airbag was deployed, replace the front seat assembly with ...