TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Audio And Visual System / Radio Receiver Power Source Circuit

Toyota Tacoma (2015-2018) Service Manual: Radio Receiver Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

CAUTION / NOTICE / HINT

NOTICE:

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)

(a) Disconnect the radio and display receiver assembly connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

R30-7 (GND1) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

R30-4 (+B1) - R30-7 (GND1)

Always

11 to 14 V

R30-3 (ACC1) - R30-7 (GND1)

Ignition switch ACC

11 to 14 V

R31-1 (IG) - R30-7 (GND1)

Ignition switch ON

11 to 14 V
Text in Illustration

*a

Front view of wire harness connector

(to Radio and Display Receiver Assembly)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
    Related Tacoma materials

    Removal
    REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before pr ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (a) Install a new gasket to the cylinder head LH. NOTICE: Be careful of the installation direction. (b) Temporarily install the exhaust manifold sub-assembly LH with the 4 nuts. (c) Tighten the 4 nuts in the sequenc ...

    Voice is not Recognized
    PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Result Proceed to System voice recognition level is low with any voice A ...