TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Sliding Roof / Sliding Roof System / Position Initialization Incomplete (B2343)

Toyota Tacoma (2015-2018) Service Manual: Position Initialization Incomplete (B2343)

DESCRIPTION

This DTC is stored when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized.

DTC No.

DTC Detection Condition

Trouble Area

B2343

Sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized.

Sliding roof ECU (Sliding roof drive gear sub-assembly)

WIRING DIAGRAM

Refer to DTC B2341 (See page CAUTION / NOTICE / HINT ).

CAUTION / NOTICE / HINT

NOTICE:

  • When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.
  • When the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, it requires initialization (See page The sliding roof system uses the CAN and LIN communication systems. ).
  • The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to the How to Proceed with Troubleshooting procedure (See page ).

PROCEDURE

1.

INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

(a) Check that the sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized (See page OK: ).

OK:

Sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized.

NG

REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

OK

2.

CHECK SLIDING ROOF OPERATION

(a) Check the sliding roof auto operation (See page OK: ).

OK:

Auto operation operates normally.

NG

REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

OK

3.

CHECK DTC OUTPUT

(a) Clear the DTCs (See page (b) Check for DTCs. ).

(b) Check for DTCs.

OK:

DTC B2343 is not output.

OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)
NG

REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

    Related Tacoma materials

    Electrical Key Oscillator(for Rear Floor)
    Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (a) Engage the clamp to install the No. 2 indoor electrical key antenna assembly. (b) Connect the connector. 2. INSTALL REAR CONSOLE BOX ASSEMBLY (See page ...

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each sy ...

    Transfer L4 Position Switch Circuit (C1268)
    DESCRIPTION A-TRAC is activated if wheel skid is detected while the transfer is in the L4 position. DTC Code DTC Detecting Condition Trouble Areas C1268 L4 detection switch signal input to skid control ECU (master cylinder solenoid ...