Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

Toyota Tacoma (2015-2018) Service Manual / Navigation / Multi Info Display / Navigation System / Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

PROCEDURE

1.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check if track information is displayed normally on another "Bluetooth" audio compatible vehicle of the same model.

OK:

Track information is displayed normally.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

PORTABLE PLAYER IS NOT COMPATIBLE

Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in ...

Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player ...

Other materials:

Radar Cruise Control Presence Determination Malfunction (Engine / HV) (C1A52)
DESCRIPTION DTC C1A52 is stored when the ECM cannot recognize the millimeter wave radar sensor assembly. DTC No. Detection Item DTC Detection Condition Trouble Area MIL C1A52 Radar Cruise Control Presence Determin ...

Clearance Sonar Main Switch Circuit
DESCRIPTION The back sonar or clearance sonar switch assembly is installed at the base of the driver side of the instrument panel. When the back sonar or clearance sonar switch assembly is turned on, an on signal is sent to the clearance warning ECU assembly. The intuitive parking assist syste ...

Initialization
INITIALIZATION 1. ZERO POINT CALIBRATION NOTICE: Make sure that the front passenger seat is not occupied before performing the operation. HINT: Perform the zero point calibration and sensitivity check if any of the following conditions apply. The occupant detection ECU is replaced. ...

В© 2011-2026 Copyright www.ttguide.net