TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Horn / Low Pitched Horn

Toyota Tacoma (2015-2018) Service Manual: Low Pitched Horn

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT LOW PITCHED HORN ASSEMBLY

(a) Check the operation.

(1) Apply battery voltage to the terminal 1 and body ground, and check that the low pitched horn assembly sounds.

Text in Illustration

*a

Component without harness connected

(Low Pitched Horn Assembly)

*b

Body Ground

OK:

Measurement Condition

Specified Operation

Battery positive (+) - Terminal 1

Battery negative (-) - Body ground

Low pitched horn sounds

If the result is not as specified, replace the low pitched horn assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL LOW PITCHED HORN ASSEMBLY

(a) Install the low pitched horn assembly with the bolt.

Torque:

20 N·m {199 kgf·cm, 14 ft·lbf}

(b) Connect the connector.

2. INSTALL RADIATOR GRILLE

Click here Removal

Removal

REMOVAL

PROCEDURE

1. REMOVE RADIATOR GRILLE

Click here 2. REMOVE LOW PITCHED HORN ASSEMBLY

2. REMOVE LOW PITCHED HORN ASSEMBLY

(a) Disconnect the connector.

(b) Remove the bolt and low pitched horn assembly.

    Related Tacoma materials

    Vehicle Speed Sensor "A" No Signal (P050031)
    DESCRIPTION Vehicles, which are equipped with ABS (Anti-lock Brake System), detect the vehicle speed using the skid control ECU (brake actuator assembly) and speed sensors. Each speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU con ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (a) Remove SST from the extension housing. (b) Install the propeller shaft to the extension housing. (c) Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange and diff ...

    Clearance Warning Ecu
    Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL CLEARANCE WARNING ECU ASSEMBLY (a) Connect the connector. (b) Engage the 2 guides to install the clearance warning ECU assembly. (c) Install the 2 screws. 2. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (f ...