DESCRIPTION
These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.
HINT:
If CAN communication system DTCs are stored, they may also be stored for other systems.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
U0100 |
Lost communication with ECM |
CAN communication system |
|
U0126 |
Lost communication with steering sensor |
|
|
U0129 |
Lost communication with skid control ECU (brake actuator assembly) |
|
|
U0142 |
Lost communication with main body ECU (driver side junction block assembly) |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page .gif)
).
(b) Check for DTCs (See page ).
|
Result |
Proceed to |
|---|---|
|
DTCs are output |
A |
|
No DTCs are output |
B |
HINT:
- If CAN communication system DTCs are stored, they may also be stored for other systems.
- If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.
- If these DTCs are output frequently, duplicate the conditions that cause
the problem symptoms and perform the inspection again, even though the DTC
was not output when rechecking for DTCs (See page
).
| A | .gif) |
GO TO CAN COMMUNICATION SYSTEM |
| B | |
USE SIMULATION METHOD TO CHECK |
