Toyota Tacoma (2015-2018) Service Manual: Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT SEATBACK HEATER ASSEMBLY
(a) Set the front seatback heater assembly with the name stamp side facing the front seatback cover.
(b) Install the front seatback heater assembly with 14 new tag pins.
2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER (for Front Passenger Side)
(See page .gif)
)
3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER (for Driver Side)
(See page
)
4. INSTALL FRONT SEAT ASSEMBLY (for Front Passenger Side)
(See page
)
5. INSTALL FRONT SEAT ASSEMBLY (for Driver Side)
(See page
)
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEATBACK HEATER ASSEMBLY
(a) Check the operation of the front seatback heater assembly.
(1) Apply battery voltage and check the operation of the ...
Other materials:
Front Occupant Classification Sensor RH Collision Detection (B1786)
DESCRIPTION
DTC B1786 is set when the occupant detection ECU receives a collision detection
signal, which is sent by the front occupant classification sensor RH when an accident
occurs.
DTC B1786 is also set when the front seat with adjuster frame assembly RH is
subjected to a strong impact, ...
Pressure Control Solenoid "G" Electrical (Shift Solenoid Valve SL4) (P2810)
DESCRIPTION
Changing from 1st to 6th is performed by the ECM turning shift solenoid valves
SL1, SL2, SL3 and SL4 on and off. If an open or short circuit occurs in any of the
shift solenoid valves, the ECM controls the remaining normal shift solenoid valves
to allow the vehicle to be operated ...
Removal
REMOVAL
PROCEDURE
1. REMOVE INTAKE MANIFOLD
(See page )
2. REMOVE WIRE HARNESS CLAMP BRACKET
(a) Remove the 2 bolts and wire harness clamp bracket.
3. REMOVE FUEL TUBE SUB-ASSEMBLY
(a) Disconnect the fuel tube sub-assembly from ...
