INSTALLATION
PROCEDURE
1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (AIR CONDITIONING CONTROL ASSEMBLY) (for Automatic Air Conditioning System)
(a) Connect the connectors.
(b) Engage the 8 clips to hazard warning signal switch assembly (air conditioning control assembly).
2. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (AIR CONDITIONING CONTROL ASSEMBLY) (for Manual Air Conditioning System)
(a) Connect the connectors.
(b) Engage the 8 clips to hazard warning signal switch assembly (air conditioning control assembly).
3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
4. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)
5. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
6. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
7. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY
8. INSTALL COWL SIDE TRIM BOARD LH
9. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab)
10. INSTALL FRONT DOOR SCUFF PLATE LH (for Access Cab)
InspectionSystem Description
SYSTEM DESCRIPTION
Text in Illustration
*a
Indication Example
*b
Tachometer
*c
Engine Coolant Temperature Receiver Gauge
*d
Speedometer
*e
Fuel Receiver Gauge
*f
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT AIR CONDITIONER PRESSURE SENSOR (for Automatic Air Conditioning System)
(a) Check the wire harness.
(1) Disconnect the A34 air conditioner pressure sensor connector.
(2) Disconnect the A35 and A36 air conditioning amplifier assembly connector.
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH side.
The procedure described below is for the LH side.
PROCEDURE
1. REMOVE REAR ACCESS PANEL WEATHERSTRIP
2. REMOVE LAP BELT OUTER ANCHOR COVER
3. REMOVE ACCESS PANEL INSIDE HANDLE BEZ ...