
Pull the seatback lock release lever and fold down the seatback.
Hold the lever until you have swung the seatback forward slightly.
Moving passenger’s seat for rear seat entry (if equipped)
Lift the seatback angle adjusting lever or press the pedal behind the seatback.
The seat will slide forward.
Move the seat to the front-most position.
■ After passengers are in the vehicle ...
Folding passenger’s seat (vehicles with seatback table)
Pull the seatback angle adjusting lever and raise the seatback to its upright
position.
Pull the seatback folding lever and fold the seatback down. ...
Related Tacoma materials
Front Differential Oil Temperature Sensor Circuit High (P17C8)
DESCRIPTION
This DTC is output when a short to B+ or open circuit in the oil temperature
sensor is detected.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P17C8
Front Differential Oil Temperature Sensor Circuit ...
CD cannot be Ejected
PROCEDURE
1.
CHECK OPERATION
(a) Press the disc eject switch of the radio and display receiver assembly for
5 seconds or more and check that the CD is ejected.
OK:
CD is ejected.
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY
...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
(a) Disconnect the 1D and 1F driver side junction block connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connectors ...