TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Ac60e Automatic Transmission / Transaxle / Extension Housing Rear Oil Seal

Toyota Tacoma (2015-2018) Service Manual: Extension Housing Rear Oil Seal

Components

COMPONENTS

ILLUSTRATION

Replacement

Replacement

REPLACEMENT

PROCEDURE

1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

(See page 2. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL )

2. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL

(a) Using SST, remove the automatic transmission extension housing oil seal.

SST: 09308-00010

3. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL

(a) Coat the lip of a new automatic transmission extension housing oil seal with MP grease.

(b) Using SST and a hammer, drive in the automatic transmission extension housing oil seal.

SST: 09309-37010

Standard depth:

5.4 to 5.8 mm (0.213 to 0.228 in.)

NOTICE:

  • Keep the lip free of foreign matter.
  • Do not tap the automatic transmission extension housing oil seal at an angle.

4. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

(See page Oil Cooler(for 2gr-fks) )

    Related Tacoma materials

    Parking Support Brake for Static Objects
    If the sensors detect a static object, such as a wall, in the direction the Toyota Tacoma is traveling and the system determines that a collision may occur, the Parking Support Brake can intervene to help reduce the impact and resulting damage. This may occur if the vehicle suddenly moves forward be ...

    Adjustment
    ADJUSTMENT PROCEDURE 1. BEFORE FILLING TRANSMISSION The AC60E automatic transmission assembly requires Toyota Genuine ATF WS. If the entire automatic transmission assembly, automatic transmission oil pan sub-assembly, drain plug, transmission valve body assembly and/or torq ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY (a) Check that the ignition switch is OFF. (b) Check that the cable is disconnec ...