TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Door Lock / Electrical Key Oscillator(for Front Floor)

Toyota Tacoma (2015-2018) Service Manual: Electrical Key Oscillator(for Front Floor)

Components

COMPONENTS

ILLUSTRATION

Installation

Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

(a) Engage the clamp to install the No. 1 indoor electrical key antenna assembly.

(b) Connect the connector.

2. INSTALL FRONT CONSOLE BOX

(See page Removal )

Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT CONSOLE BOX

(See page 2. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY 2. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY )

2. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

(a) Disconnect the connector.

(b) Using a clip remover, disengage the clamp to remove the No. 1 indoor electrical key antenna assembly.

    Related Tacoma materials

    Data List / Active Test
    DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may ...

    Utility
    UTILITY NOTICE: When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle. A ...

    Freeze Frame Data
    FREEZE FRAME DATA 1. FREEZE FRAME DATA (a) Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data. 2. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on ...